2014 Truck Pull

DEPARTMENT V

4 WHEEL DRIVE TRUCK PULLS


SUPERINTENDENT: KATHY OSTRANDER

 

SATURDAY, AUGUST 16th 2014
    Class 1 -- Diesel / Work Stock 8500lbs.
    Class 2 -- Open Diesel 8000lbs.
    Class 3 -- Street Modified 5800lbs.
    Class 4 -- Street Modified 6200lbs.

WEIGH INS: 3:00pm to 6:00pm        SHOWTIME: 6:30PM


SUNDAY, AUGUST 17th 2014
    Class 1 -- Street Legal Stock 6800lbs.
    Class 2 -- Street Legal Stock 6800lbs. ENHANCED

WEIGH INS: 4:00pm to 6:30pm    SHOWTIME: 7:00pm

 

PREMIUMS:  1st $150.00 & Trophy, 2nd $60.00, 3rd $35.00

( PREMIUMS WILL BE PRORATED IF LESS THAN 10 ENTRIES PER CLASS )

SPONSORED BY

HARBOR POINT ENERGY PRODUCTS

MID VALLEY AUTOMOTIVE ILION NY and 4 SEASONS TIRE & AUTO REPAIRS

BEST LOOKING MODIFIED TRUCK by JULIANO'S SAND & GRAVEL


GENERAL RULES

  1. ALL DRIVERS AND HELPER MUST BE 18 YRS OF AGE BY DATE OF PULL AND HAVE A VALID DRIVERS LISCENSE.
  2. ALL DRIVERS MUST WEAR A HELMET AND SEAT BELT, NO PASSENGERS ALLOWED.
  3. ALL TRUCKS MUST HAVE A FIRE EXTINGUISHERS (2LBS. ABC) AND MUST BE WITHIN DRIVERS REACH.
  4. NO ALCOHOL ALLOWED IN PIT OR SHOW RING AREA.
  5. TRUCKS MAY BE ENTERED ONLY ONCE IN EACH CLASS
  6. TIRES SHALL NOT BE EQUIPPED WITH STUDS, CHAINS, NO ALTERED TIRES.
  7. ALL HITCHES WILL BE INSPECTED AT WEIGH-IN, JUDGES WILL HAVE THE RIGHT TO DISQUAILFY ANY UNSAFE HITCHES.
  8. HITCH MUST NOT BE OVER 26 INCHES, MUST HAVE 3-3 1/2" HOLE, HOOK MUST DROP STRAIGHT DOWN.
  9. STREET CLASSES MUST HAVE VAILD INSPECTIONS, REGISTRATIONS AND PLATES EXCEPTIONS DEALER PLATES ALLOWED.
  10. ALL WEIGHTS MUST BE SECURED INSIDE TRUCK BODY ONLY.NO WEIGHTS OUT FRONT, NO HIDDEN WEIGHTS. NO EXCEPTIONS. ANY LOOSE WEIGHTS ON TRUCKS IS AN IMMEDIADTE DISQUALIFICATION. DECISION OF JUDGES IS FINAL.
  11. TRUCK AND SLED MUST STAY WITHIN BOUNDERY LINES
  12. PULL IS OVER WHEN FORWARD MOTIONS STOPS.
  13. IF BEAKAGE OF OCCURS, PULL WILL BE OVER AT THAT POINT.
  14. ALL DRIVERS MUST OBEY FLAGMAN'S SIGNALS.
  15. DRIVERS WILL BE DISQUALIFIED FOR RECKLESS OPERATIONS BEFORE, DURING AND AFTER THE PULL. THIS INCLUDES PIT AREA.
  16. ALL MOTORS MUST BE EQUIPPED WITH AN AIR BREATHER.
  17. NO WEIGHTS OR AIR PRESSURES WILL BE CHANGED AFTER CROSSING SCALES.
  18. NO TEST PULLS ALLOWED UNLESS SLED OPERATOR CHANGES MACHINE OR WEIGHTS.
  19. ANY ODD OR QUESTIONABLE MODIFICATIONS MUST BE APPROVED BY EVENT OFFICIALS.

 

GENERAL REGISTRATIONS

  1. ALL DRIVERS AND PIT PERSON MUST FILL OUT ENRTY FORM AND SIGN RELEASE WAIVER.
  2. A NONREFUNDABLE ETRY FEE WILL BE $25 PER CLASS ENTERED.
  3. EACH DRIVER WILL BE ALLOWED TO PURCHASE 2 WRIST BAND AT A COST OF $10 THAT WILL ALLOW THE DRIVER AND ONE HELPER OVER THE AGE OF 18 TO GAIN ACCESS TO FAIRGROUNDS.
  4. ORDER OF PULL WILL BE DETERMINED AFTER REGISTRATION IS COMPLETE.
  5. NO ONE ALLOWED IN SHOW RING DURING PULL EXCEPT PULL OFFICIALS AND TRUCK'S DRIVER AT TIME OF PULL A SEPARATE SEATING AREA IS AVAIBALE FOR DRIVERS AND HELPERS. THE PULLS WILL BE DELAYED IF THIS RULE IS NOT ADHERED TO.


GENERAL RULES FOR STOCK & DIESEL CLASSES

  1. STOCK IS STOCK. NO EXCEPTIONS. MOTORS MUST BE CORRECT IN CHASSIS (FORD TO FORD) & MODEL YEAR AND MOTOR MUST COMPLY. FLOOR BED MUST BE SOLID WHEEL BASE MAY NOT BE CHANGED FROM ORIGINAL MANUFACTOR WOODEN FLATBEDS ARE PERMITTED
  2. NO ALUMINUM INTAKES OR HEADERS, CAST IRON MANFOLDS ONLY, NO EXCEPTIONS, NO DOUBLE PUMPERS.
  3. EXHAUST SYSTEMS WILL BE CLOSED - MUST HAVE MUFFLER, NO HOMEMADE MUFFLERS.
  4. TIRES MUST BE DOT APPROVED
  5. NO SOLID SUSPENSIONS, TRUCKS MUST HAVE A WORKABLE SUSPENSION WITH A MINIMUM OF 2 INCHES OF MOVEMENT AT ALL TIMES. LIFT KITS AND SNOW PLOW FRAMES ARE ACCEPTABLE NOT TRACTION BARS NO OUTRAGEOUS SPRING STACKS
  6. NO OTHER HITCHES ALLOWED. HITCH POINT MAY NOT BE MORE THAN 26" FROM THE GROUND. NO ANGLED, LEVEL, PIVOT, OR AXIS HITCHES ARE ALLOWED AND THE HITCH MUST BE SATISFACTORY IN ALL DIRECTIONS. THE HOOK POINT MUST BE PAST THE BED OF THE TRUCK. THE HOLE FOR HITCHING MUST ACCOMMODATE A MINIMUM OF 3 INCHES ACROSS. NO DRAW BARS ALLOWED
  7. ALL WEIGHTS TO BE IN BOX ONLY, NO WEIGHTS OUT FRONT, NO HIDDEN WEIGHTS, NO EXCEPTIONS, 8.ALL WEIGHTS TO BE SECURED, AND NO LOOSE WEIGHTS.
  8. GAS FUEL IN THE FUEL INJECTED CLASS ONLY, NO AFTER MARKET FUELS ALLOWED.
  9. CARBURATED TRUCKS. ONLY 4 BARREL CARBURATORS WITH NO MORE THAN ONE INCH SPACERS.

 

IF YOUR TRUCK DOES NOT CONFORM TO THESE RULES YOU WILL NOT PULL IN STOCK CLASSES.

SPECIAL RULES TO THIS DIESEL CLASS

  1. This is an open street legal truck class available to owners of trucks that are used on the highway. If your truck is street legal and is built to the general rules set forth herein, you can enter this class. Your registrations papers are required to prove that the truck is street legal. A license plate is required to be affixed to the truck. Registration and license must match and will be compared.
  2. No aluminum engine blocks are permitted unless O.E.M. No open headers will be allowed. Pump diesel fuel is the only permitted fuel. Headers are approved but all exhaust must run through a muffler system. A single turbo charge maximum permitted on diesel trucks. Engines must be stock.
  3. Weights on the front of the vehicles must be securely fastened to the truck and must not exceed more than 60 inches from the center line of the front wheel.
  4. No Water to Air Cooler


STREET MODIFIED - 6400lbs.

  1. ALUMINUM INTAKE AND HEADERS ARE ALLOWED AND MAY USE A MAXIMUM 2" CARBURATOR SPACE WITH NO VISABLE MODIFICATIONS. TRUCKS MAY USE ANYTHING FOR CARBURATORS BUT ONLY USE ONE
  2. MOTOR MUST BE NATURALLY ASPIRATED.
  3. TRUCKS MAY HAVE AN OPEN EXHAUST.
  4. TRUCKS MAY USE ANYTHING FOR A CARBURATOR BUT ONLY 1 WILL BE ALLOWED,
  5. ONLY CAST IRON BLOCKS ALLOWED.
  6. GASOLINE AND RACING GASOLINE ONLY NO NITOROUS ALLOWED.
  7. TRUCKS MUST PULL FROM A CLASS 3 OR DRAWBAR HITCH. HITCH MUST BE SAGE (NO PULLING FROM BUMPER) HITCH LENGTH TO BE A MINIMUM OF 36% OF WHEEL BASE FROM CENTER OF REAR AXLE TO POINT OF HOOK.
  8. TRUCKS MUST HAVE 4 WHEEL WORKING BRAKES.
  9. ANY DOT TIRE APPROVED EXCEPT WRANGLER XT.
  10. NO SOLID SUSPENSIONS, TRUCKS MUST HAVE A WORKABLE SUSPENSION. TRACTIONS BARS ARE ALLOWED.
  11. NO PLOW FRAMES.
  12. WHEEL BASE NOT TO EXCEED 133 INCHES.
  13. ALL TRUCKS WITH STANDARD TRANSMISSIONS MUST HAVE A STEEL BELL HOUSING OR MUST BE EQUPPIED WITH A 3 STRAP TRANSMISSION BLANKET ON THE BELL HOUSING.
  14. ALL TRUCKS WITH AUTOMATIC TRANSMISIONS WILL HAVE A TRANSMISSION BLANKET OR SFI APPROVED 360 SHIELDS EXTENDING FROM THE BELL HOUSING TO TAIL SHAFT. ONE SEVEN STRAP OR 2 THREE STAP BLANKETS ARE ALLOWED.
  15. THREE DRIVE SHAFT HOOPS ARE MANDATORY OVER EACH SHAFT, 3/8" ALUMINUM OR 5/16" STEEL BY %" WIDE. ONE STRAP EACH DRIVE MUST BE WITHIN 6" OF EVERY U-JOINT, MAXIMUM 10"
  16. AXLE HUB GUARDS MUST BE A MINIMUM OF 3/16 ALUMINUM OR 1/16" STEEL THEY MUST COVER 2/3RD OF HUB END.
  17. ALL TRUCKS MUST HAVE OPERATIONAL KILL SWITCH AND WILL BE TESTED BEFORE PULL.
  18. ALL KILL SWITCHES MUST BE MOUNTED INDEPENDENTLY OF DRAWBAR, CABLE END MUST HAVE A LOOP TO ATTACH TO SLED CABLE AND MUST BE LOCATED IN THE REAR CENTER OF TRUCK, MINIMUM OF 14" ABOVE HITCH AND A MAXIMUM OF 6" OFF CENTER IN EITHER DIRECTIONS.
  19. TRUCKS CAN HAVE WEIGHT BAR. NOT TO EXCEED 60 INCHES FROM CENTER OF FRONT AXLE OF WEIGHT RACK. WEIGHTS MUST BE SECURED.
 

Driving Directions

Use Google Maps to find quick and easy directions to the fairgrounds!

2015 Fair Opening Countdown

Time till Opening Ceremonies
Time till Opening Ceremonies

Public Fairgrounds Events

SEPTEMBER
13th Craft Fair
19th - 21st 4-H Cattle Show and Sale
27th Lambrecht's Auction